Avocent Access Router Cyclades-PR2000 Bedienungsanleitung Seite 59
- Seite / 136
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Cyclades-PR2000
59Chapter 8 - Data-Link Protocols (Encapsulation)
Add DLCI Menu CONFIG=>INTERFACE =><LINK> =>ENCAPS =>FRAME RELAY =>
<ESC>
=>ADD DLCI
Parameter Description
DLCI Number Used to identify the DLC. This number is supplied by the Public Frame Relay network
provider. The DLCIs are stored in a table which can be seen with the
L
command.
Frame Relay Address
Map
Determines the method used for mapping the remote IP address to the Permanent
Virtual Circuit.
Static
maps one IP address to this DLCI.
Inverse ARP
maps the IP
address dynamically, in a manner similar to the ARP table.
IP Address Applies when
Frame Relay Address Map
is
Static
. Provides the IP address to be used
for static address mapping.
Enable Predictor
Compression
Enables data compression using the Predictor algorithm. This feature should be
enabled only if Cyclades' equipment is being used on both ends of the connection
because there is no established standard for data compression interoperability. Data
compression is very CPU-intensive, making this feature effective only for links running
at speeds under 1Mbps. At higher speeds, the time necessary to compress data
offsets the gains in throughput achieved by data compression.
Number of Bits for
Compression
Applies when
Predictor Compression Enabled.
Sixteen is fastest, but 10 must be
used if the router on the other end is a PathRouter, for compatibility.
DLCI Priority Level This is the equivalent of CONFIG=>RULES LIST=>IP =>CONFIGURE RULES=>ADD
RULE=>FLOW PRIORITY LEVEL. See the section on traffic control in chapter 16.
Reserved Bandwidth This is the equivalent of CONFIG=>RULES LIST=>IP =>CONFIGURE RULES=>ADD
RULE=>RESERVED BANDWIDTH. Defines what percentage of the total bandwidth
on an interface will be set aside for this DLC. See the section on traffic control in
chapter 16.
Bandwidth Priority
Level
This is the equivalent of CONFIG=>RULES LIST=>IP =>CONFIGURE RULES=>ADD
RULE=>BANDWIDTH PRIORITY LEVEL. See the section on traffic control in chapter
16.
To edit the DLCI table, use the list command (CONFIG=>INTERFACE=><LINK>=>ENCAPSULATION
=>FRAME RELAY=>L) to discover the number CyROS has assigned to each table entry. It will not be the
same as the DLCI.
- Cyclades-PR2000 1
- Table of Contents 3
- Table of Contents 4 4
- Table of Contents 5 5
- Table of Contents 6 6
- CHAPTER 2 WHAT IS IN THE BOX 12
- Back Panel of PR2000 13
- DB-25 Male 13
- RJ-45 Male 13
- RJ-45 TO DB-25 13
- Special Keys 16
- Cyros Management Utility 17
- Configuration Menu Interface 18
- End HTTP Session 18
- STEP ONE 20
- Mode Asynchronous 21
- Speed 38.4k 21
- Global Assigned 22
- STEP FOUR 23
- Interface 24
- First IP Address 192.168.0.10 25
- Last IP Address 192.168.0.30 25
- Clock Source 29
- External 29
- STEP THREE 30
- Inactive 31
- STEP FIVE 32
- Address Based 38
- Unnumbered 41
- Numbered 41
- IP Bridge 43
- FIGURE 5.1 IP BRIDGE EXAMPLE 43
- Chapter 7 Network Protocols 48
- The IP Protocol 49
- PPP Menu (Continued) 53
- HDLC Keepalive Interval 55
- Add DLCI 55
- <ESC> 59
- Throughput 62
- N3 Window 62
- IP Address Type 63
- Predictor Compression Enabled 63
- Static Routing 64
- Dynamic Routing 64
- Point-to-Point Connection 66
- RIP2 Authentication 68
- FIGURE 9.3 OSPF EXAMPLE 69
- Enable Inactive 70
- OSPF on This Interface 70
- Disabled 70
- OSPF Global Configurations 72
- Virtual Link Status 75
- STEP TWO 79
- 100.10.0.0/16 81
- ROUTE MAP 82
- =>ADD 83
- STEP SIX 84
- • creation of the host table 87
- • IP Accounting 87
- FIGURE 11.1 NAT EXAMPLE 90
- Chapter 11 - NAT 91
- Types of Address Translation 92
- Normal Mode 93
- First IP Address 94
- Last IP Address 94
- FIGURE 12.2 FIREWALL EXAMPLE 98
- Exterior Router 99
- Default Scope 99
- <INTERFACE> 100
- Requests 109
- ACKs Back 109
- Data Requested 109
- E-mail out 109
- Flow Priority 110
- Reserved Bandwidth 110
- Bandwidth Priority 110
- Chapter 13 - IPX 111 111
- Chapter 13 - IPX 112 112
- Send SAP Update 113
- Periodic 113
- Frame Relay 113
- Chapter 13 - IPX 114 114
- As received by 115
- Important!! 116
- REMOTE SECURITY NETWORK 2 117
- LOCAL SECURITY NETWORK 117
- REMOTE SECURITY NETWORK 1 117
- IP Address 122
- Subnet Mask 122
- Cyclades - PR2000 125
- General Specifications 126
- The WAN Interfaces 127
- The LAN Interface 127
- The Asynchronous Interface 128
- The Console Interface 128
- The Straight-Through Cable 129
- DB-25 - M.34 Adaptor 130
- The ASY/Modem Cable 131
- The Cross Cable 131
- DB-25 Loopback Connector 133
- Index 135 135
Verwandte Produkte und Handbücher für Hardware Avocent Access Router Cyclades-PR2000
Hardware Avocent DSR8035 Bedienungsanleitung
(230 Seiten)
(230 Seiten)
Hardware Avocent CCM4850 Bedienungsanleitung
(100 Seiten)
(100 Seiten)
Hardware Avocent EVR1500-AM Bedienungsanleitung
(79 Seiten)
(79 Seiten)
Hardware Avocent 5240 Bedienungsanleitung
(88 Seiten)
(88 Seiten)
Hardware Avocent ACS V6000 Bedienungsanleitung
(58 Seiten)
(58 Seiten)
Velas V-M300U manuels
Manuels d'utilisation et guides de l'utilisateur pour Haut-parleurs pour voitures Velas V-M300U.
Nous fournissons des manuels en pdf 1 Velas V-M300U à télécharger gratuitement par type de document : Manuel de l'utilisateur
Kommentare zu diesen Handbüchern