Avocent ECMS2000U Betriebsanweisung PDF herunterladen (Seite 48)

42 Emerge Digital Extender System Installer/User Guide

5. Press 2 to select Transmitter IP Config and press Enter. The Transmitter IP Config menu will

appear. The old Transmitter IP address is displayed beside menu option 1.

Figure 3.22: Transmitter IP Configuration Menu on the ECMS User Station

NOTE: This screen is available only in Extender Mode.

6. Press 3 to select Detect Transmitter Address and press Enter.

7. Turn on the transmitter.

8. The ECMS user station will detect and save the IP address of the connected transmitter. The

Transmitter IP Configuration Menu will refresh, and the current IP address of the connected

Transmitter will be displayed beside menu option 1.

9. To save your changes and exit the menu, type 0 (zero) and press Enter.

Authentication

By default, two passwords are required to access the Emerge digital extender system via the serial

menu. One password is for access to the serial menus that control the ECMS user station. The other

password is for access to the serial menus that control the transmitter. In both cases, the default

password is password.

Authentication for the ECMS user station

You can change the password settings for the ECMS user station through the serial menu via the

Receiver Security Configuration Menu.

To access the Receiver Security Configuration Menu:

1. Press Enter to display the serial menu. The Appliance Selection Menu will be displayed.

2. Press 1 to access the Receiver Main Menu and press Enter. If the password option is enabled,

you will be prompted for a password.

3. Type the password and press Enter. The Receiver Main Menu will appear.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 91 92

Keine Kommentare

Avocent ECMS2000U Betriebsanweisung Seite 48