Avocent ECMS2000U Betriebsanweisung PDF herunterladen (Seite 31)

Operations

Overview

Operating a workstation through the Emerge digital extender system is no different than working

directly connected to your workstation. All peripherals operate as if directly connected, even

though the workstation is located at a distance. When you turn on the ECMS user station, a

connection is automatically established with the workstation.

While the default settings of your Emerge digital extender system will work in most environments,

you may configure the settings to better fit your system. Internal settings such as connection

settings can be configured via the serial menu. You can also upgrade the Emerge digital extender

system via the serial menu. See Flash Upgrading your Emerge digital extender system on page 45

for more information.

The administrator can configure Desktop Mode so that there is a fixed association between a user

station and the target PC. A user can have a fixed association with a specific target PC or have

access to other target PCs. The user may choose which target PC to connect to via the OSD.

LED identification

Front panel

There are two blue LEDs on the front panel of an ECMS user station. The PWR LED will light up

when the user station has been turned on. The ACTIVE LED will blink slowly until the user station

establishes a connection with the transmitter. When a connection has been established between the

user station and transmitter, the ACTIVE LED will stop blinking and will remain lit.

Rear panel

Two LEDs are built into both the RJ-45 connector on the rear of the user station and into the RJ-45

connector on the transmitter.

CHAPTER

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 91 92

Keine Kommentare

Avocent ECMS2000U Betriebsanweisung Seite 31