Avocent Server ACS 6000 Bedienungsanleitung PDF herunterladen (Seite 23)

set ipv4_method=dhcp

#set ipv4_method=static #ipv4_address=192.168.160.10 #ipv4_

mask=255.255.255.0

#set ipv4_method=ipv4_address_unconfigured

#set ipv6_method=stateless

#set ipv6_method=dhcpv6

#set ipv6_method=static #ipv6_address= #ipv6_prefix_length=

set ipv6_method=ipv6_address_unconfigured

set mode=auto

submit

echo on

commit

--:- eth0 cli->

NOTE: Check the configuration of the program used to open a session against the appliance (SSH/Telnet,

TeraTerm / HypertTerminal for console, and so on) to avoid the inclusion of a line feed character in lines that exceed

terminal width, because this will affect the past operation.

cycle, on, off, lock and unlock

Control power on outlets on a PDU that is either connected to a serial port or to the

AUX/Modem port when the port is enabled and configured with the Power Profile.

NOTE: Lock and unlock commands are only supported on Cyclades and Avocent PDUs.

To power control (on, off, cycle) all outlets of PDUs or outlets merged to a target

(serial port configured as CAS profile with merged outlets):

1. Go to the access level.

--:- / cli-> cd/access

2. Launch the power command with the argument being the target name or PDU ID.

--:- access cli-> [cycle|on|off][<PDU_ID>]|<target name>]

To power control (on, off, cycle) outlets of one specific PDU:

1. Go to the PDU level under access.

--:- / cli-> cd access/<PDU_ID>

2. Launch the power command with a specific outlet (number or name), range of outlets (use a

hyphen to specify the range) or list of outlets (number or name separated by a comma).

--:- <PDU_ID> cli-> [cycle|on|off][<outlet name>|<outlet number>]

-or-

--:- <PDU_ID> cli-> [cycle|on|off]<outlet number>-<outlet number]

-or-

Chapter 2: CLI Command Set 15

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 72 73

Keine Kommentare

Avocent Server ACS 6000 Bedienungsanleitung Seite 23