Avocent HMX Manager Betriebsanweisung PDF herunterladen (Seite 12)

6 HMX Manager Installer/User Guide

To connect the HMX Manager appliance:

WARNING: To reduce the risk of electric shock or damage to your equipment:

- Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.

- Disconnect the power from the target computer by unplugging the power cord from either the electrical outlet or

the target computer.

1. Attach one end of the supplied power cord into the back panel of the HMX Manager appliance

and attach the other end to an appropriate AC power source. The HMX Manager appliance has

power control button on the front panel.

2. Connect the LAN Port 1 Ethernet port on the back panel of the HMX Manager appliance to the

LAN to which the transmitters and user stations are connected using standard UTP cables.

NOTE: The transmitters and user stations must be connected to LAN port 1. However, you can access the HMX

Manager appliance using the browser on a computer connected to either LAN port 1 or LAN port 2.

Configuring Network Settings

To assign an IP address to the HMX Manager appliance, you must establish a connection to the

serial menu first, then use the options on the serial console menu to configure the network settings

for each of the LAN ports on the HMX Manager appliance.

NOTE: If you are connecting to only one LAN, only LAN port 1 needs to be configured.

To configure the network settings of the HMX Manager appliance:

1. Connect a terminal or a computer that is running a terminal emulation program to the serial

port on the back panel of the HMX Manager appliance.

2. Start a session with the following port settings:

• Serial speed: 9600 bps

• Data length: 8 data bits

• Parity: None

• Stop Bits: 1

• Flow Control: None

3. Once a connection is established, a serial console menu appears.

4. Type 2 to configure any of the following network settings:

• Set eth speed

• Choose using DHCP or defining an IP address

• Type subnet mask

• Type gateway IP address

• Select default gateway

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Keine Kommentare

Avocent HMX Manager Betriebsanweisung Seite 12