Avocent HMX Manager Betriebsanweisung PDF herunterladen (Seite 22)

16 HMX Manager Installer/User Guide

Changing unit properties

The HMX Manager appliance enables you to manage the department and location properties as

well as the primary contact details for each unit.

To change the properties of a unit:

1. Click the Units tab. A list of all units managed by the HMX Manager appliance is displayed.

2. Click the unit name you wish to change. The Unit Overview window will open.

3. Select Properties from the side navigation bar.

4. The Unit Properties window will open. This window displays all the general properties of the

unit. Edit the properties you wish to change.

NOTE: Part Number (MPN), Serial Number (EID) and model type are read-only values. These values are read

from a unit during discovery and cannot be changed.

5. Click Save and then click Close.

Configuring network settings for a transmitter or user station

The administrator can use the HMX Manager appliance to change a unit's IP address, subnet mask,

default gateway and DHCP status. These changes can be done from the Unit Settings menu

available in the side navigation bar of the Unit Overview window. Once you have implemented the

changes, the unit will reboot.

All configuration options under the Unit Settings menu in the side navigation window involve live

communication with a transmitter or user station. The transmitter or user station must be turned on,

discovered and added for the HMX Manager appliance to display its properties.

If the HMX Manager appliance cannot communicate with a transmitter or user station, it will

display the following communication error: An error was encountered communicating with the

Unit. Please check the unit's network settings and connectivity.

To change the network settings of a managed unit:

1. Click the Units tab. A list of all units managed by the HMX Manager appliance is displayed.

2. Click the unit name whose network settings you wish to change. The Unit Overview window

will open.

3. Click Network under Unit Settings in the side navigation bar. The Unit Network Settings

window will open.

• Type an address, subnet and gateway in standard dot notation (xxx.xxx.xxx.xxx).

• Enable or disable DHCP.

4. Click Save and then click Close.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Keine Kommentare

Avocent HMX Manager Betriebsanweisung Seite 22